Intro to Fab - Laser Cutter

A logo of my initials C. L. C

The idea for this assignment was very simple. I wanted to make coasters using my logo shown on the left. To make this assignment more interesting, I wanted to mix two materials: material board and acrylic. I used boards that were 1/8’ thick. To minimize burns on my material board, I covered the surface with tape.

With my finished cuts of acrylic and material board, I cleaned them and put them together with superglue. I then decided to sand the acrylic to make it smoother even though I knew I would lose the transparency.

To further improve on this assignment, I would like to use the wax machine located in the basement of the building. This would provide a smoother finish to my coasters.